Composite Columns for B.Y.

Thank you for reaching out.  Yes, we finished the project and are very happy with the results.   The only issue we had was with the unloading of the materials.
I’m not sure if you sell a plate or something that can serve as a cap, but as you can see in the photos the tops are not completely covered and we had to cut pieces to seal off the open tops.   Had I to do it again, I may have gone with thin sheet of aluminum or flashing that was cut to fit over the whole install rather than cutting two rectangles to cover each side.
Attached are a couple quick photos the installation.   The photos were not taken with the mindset of showing off the columns themselves.   If you would like,  I can try to get more that might show the columns a little more.